WarpTwo Multicast Router
Hardware Features (by Model)
WarpTwo.1 features
WarpTwo.6 Features
WarpTwo.1 features
ISDN BRI U interface (embedded
NT1)
The WarpTwo range connects to an ISDN line using the U
interface (only available in North America). Each WarpTwo unit has an
embedded NT1. Many of our competitor's routers connect to an ISDN line
using the S/T interface which requires the purchase of an NT1 (Network
Termination 1) device which can cost $200 - $300.
10MB Ethernet LAN
interface
The WarpTwo.1 has a single
10MB Ethernet LAN connection using 10baseT (twisted pair) and provides an RJ45
female socket to facilitate this connection.
Power
Connector
The WarpTwo range uses a 9
Volt, 1 Amp. transformer. To facilitate connection the WarpTwo range provides a
'desktop' transformer whereby the Power connector uses only a single power socket connector. The WarpTwo.1 does not provide an ON/OFF switch since it is designed for
continuous operation.
8 LED Display
WarpTwo.1 provides an 8 LED
display allowing the user 'at a glance' to monitor the state of the ISDN,
LAN and network connections. ZyTrax, in addition, provides a monitor utility
to replicate the LED display on a PC for use when the router is located in a
wiring closet or some other inaccessible location.
WarpTwo.6 Features
ISDN BRI U Interface (embedded NT1).
WarpTwo range connects to an ISDN line using the U
interface (only available in North America). Each WarpTwo unit has an
embedded NT1. Many of our competitor's routers connect to an ISDN line
using the S/T interface which requires the purchase of an NT1 (Network
Termination 1) device which can cost $200 - $300.
10MB Ethernet 6 Port Hub (with Uplink switch)
The WarpTwo.6 has a single 10MB Ethernet LAN connection using 10baseT (twisted pair)
and provides an RJ45 female socket to facilitate this connection.
20 LED Display
WarpTwo.6
provides a 20 LED display allowing the user 'at a glance' to monitor the state
of the ISDN, LAN HUB and network connections. WarpTwo.6 dedicates
12 LEDs for display of the HUB status the remaining 8 LEDs are common with the
WarpTwo.1. ZyTrax in addition provides a monitor utility to replicate the LED
display on a PC for use when the router is located in a wiring closet or some
other inaccessible location.
Power Connector
The WarpTwo range uses a 9 Volt, 1 Amp.
transformer. To facilitate connection the WarpTwo range provides a 'desktop'
transformer whereby the Power connector uses only a single power socket connector.
On/Off switch on front
panel
WarpTwo.6 provides a conveniently located ON/OFF switch. In general WarpTwo routers are intended for continuous operation.
